Skip to main content

Parts Shaker

I've build a parts shaker to knock the edges and burrs off the laser cut parts. I used an old thermo fan from the Mazda and cut 3 of the blades of to unbalance it. I screwed this to a piece of wood with 20ltr bucket on it that hangs from the roof. I'm running the thermo fan from an old ATX power supply that I had lying around. I experimented with both wet and dry sandblasting grit as a medium, the wet medium seemed to work quicker but also the part start to rust.



I left the parts in the shaker for about 4-5hrs by which time the edges where smoothed off and some of the surface treatment had lifted. I then coated the parts in Phosphoric Acid (Rust Remover) and coated them in Pentrol pending welding together once dry.


If funds allow I'd like to purchase a powered coating gun and powder coat the sub-frame as I have an old oven in the shed I can use to cook it off.


Comments

Post a Comment

Popular posts from this blog

Shortening the Diff

I have a Ford 8.8 inch diff from a EF/EB Ford Falcon with a Limited Slip Differential. I want to shorten it down to suit the 323. Due to the RX7 LCA in the front, the front tyres(205X50X15) now protrude from the front guards by 65mm. Making the overall front track width 1,675mm. With 225X50X15 tyres on the rear and the standard diff the rear is 1,610mm. Meaning that the rear track width is 32.5mm narrower on each side. To widen the rear when I shorten it, I'll make the rear axle 65mm wider than the standard rear axle. The standard 323 Diff width is 1,338mm and the Ford 8.8 is 1,547mm for a total difference of  209mm. So the Diff needs to be shortened by 209mm - 65 =  144mm or 72mm per side.
Post a Comment
Read more

Finished design of front suspension Rx7 FC to 323 sub-frame

So I threw out the original design as I didn't like a few aspects of it, mainly being that it was overly complicated, not as flexible with the position of the steering rack to the Lower Control Arms(LCA) and not as strong. To address some of these design flaws i re-designed it around some 25X50X2.5 rectangular stock I had in the shed. I also changed the design of the brackets for the power steering rack to make them easier to position providing more flexibility during construction. I've made the height of both the the LCA's and the steering rack adjustable by 60mm in three 20mm increments. The I've sent the parts of to the laser cutters to be cut in 3mm mild steel with all the files available here . Once they are back I'll mig weld them together as I don't posses a TIG welder at this time. New Sub-Frame Design Old Sub-Frame Design I built the old design in cardboard after printing it on paper sticking it to the cardboard and cutting it out. This...
Post a Comment
Read more

Mazda_323

Mazda_323 The above link is for a suspension model I measured from the stock Mazda 323 suspension and setup in  the model creating tool at Racing ASP to assist in mapping the stock Roll Center and predicting the new roll center with the RX7 FC Suspension.
Post a Comment
Read more